A nice big piece of Pye

[madlabs]

https://www.mouser.com/ProductDetail...dji2uRYA%3d%3d

This should work for the 1.6K

https://www.mouser.com/ProductDetail...dji2uRYA%3d%3d

A little smaller than 30mm, 25mm.

Are you using 1 watters for the 1/2 watters?

[Jon A.]

Originally Posted by madlabs

https://www.mouser.com/ProductDetail...dji2uRYA%3d%3d

This should work for the 1.6K

https://www.mouser.com/ProductDetail...dji2uRYA%3d%3d

A little smaller than 30mm, 25mm.

Are you using 1 watters for the 1/2 watters?

That 1.62 looks good, thanks. Edit: Oh shoot, that's a non-stocked item.

The same link was pasted twice; I've made that mistake many times. Actually it's the 18k 2-watt carbon composition resistor that's about 30mm long; I have no idea what to replace that with. I'm using 2-watt resistors to replace the old 1/2 watters. Bob Andersen said he does this, they're approximately the same physical size.

To sum it all up I plan to use 2-watt metal film resistors in place of the old 1/2 watters and 3-watt to replace the old 1-watters as they're very close in size. I have no idea what I'll do about that 2-watt carbon composition fatty or the 1.6k 4-watt resistor.

I got a close-up of the circuit the 1.6k 4-watt resistor is in, highlighted it and identified the tubes in the area, hopefully that helps.