|
|
|
#11
11-06-2017, 11:50 PM
|
|||
|
|||
|
I then got to work on re-stuffing the E-Cap (C2). I'll use my usual method of cutting off the base right at the bottom of the can, clean it all out, true up the parting surfaces of both the base and the can. I enlarged the hole in the middle of the base to 5/32. Then I epoxy a 1 inch tall piece of PVC pipe to the base. Making sure there is no epoxy on the outside which will interfere with a good seam where the base and can meet. Tomorrow I'll add the replacement E-Caps.
  
Last edited by Crist Rigott; 11-07-2017 at 12:03 AM. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode