|
|
|
|
|
#1
10-25-2018, 12:24 AM
|
|||
|
|||
|
I restuffed the E-Caps today. I usually use Nichicon 105 degree caps, but this time Mouser had some from a new supplier. The specs looked good and they all had a 12,000hour rating! So I ordered what I needed. Here is a link:
https://www.mouser.com/ProductDetail...XL451ELL121MM3 I used my usual method of using a PVC sleeve. All of these E-Caps has a cardboard cover so I made the parting surface up from the base. When the can goes back on I'll run a layer of tape over the seam to secure the can and then slide on the cardboard cover.     
Last edited by Crist Rigott; 10-25-2018 at 12:28 AM. 
|
|
#2
10-25-2018, 08:56 AM
|
||||
|
||||
|
Nice set! Those were shunned back in the '80's, but they sure look good today. If you can't find a back, look up perforated steel sheets on eBay. With snips and grinding wheel you can make a real nice convincing back. Some use fiberboard (which was likely used originally), but it's a bear to make the many ventilation holes straight and clean-cut.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
