Motorola TS-4J

[timmy]

Originally Posted by Zsuttle

Well, I had replaced all of the caps in the sweep circuits. Later today I'll try injecting a composite signal and seeing where that gets me.

~Zach

It may be possible that the alignment is out just a little, if you check the schematic you can very slightly move the channel 3 adjustment on top of the chassis, but do make sure you have a good signal to start with.

[Zsuttle]

Well, tried injecting a signal, couldn't get it to go through the way I wanted. I've combed over the horizontal, vertical, and sync and cannot seem to locate the problem. Is it possible that it's emanating from earlier in the circuit in one of the video sections? The picture appears darkened and has the horizontal jitter. The frame is not centered all of the way, with a little black bar at the bottom.