|
|
|
|
|
#2
11-01-2019, 09:32 AM
|
||||
|
||||
|
Okay, so diodes x1-x3 were removed from the circuit, tested fine, and reinstalled. M1 was also removed, checked good, and reinstalled. Still no life.
I'm looking at removing R119 and doing a continuity check across it next. This has to be early in the line. Where would you all recommend I measure next? I have the cord out of the cabinet and I'm ready to take voltage measurements.
__________________
To keep your tubes running smoothly, make sure to dust underneath the glass as well. 
|
|
#4
11-01-2019, 02:10 PM
|
||||
|
||||
|
I'm going to assume no on at least one of them. I'll plan to check them either tonight or tomorrow, depending on my schedule. I think I may also take a look at C1 again, just to see if it's got any amps going across it.
__________________
To keep your tubes running smoothly, make sure to dust underneath the glass as well.
|
|
#5
11-01-2019, 02:54 PM
|
||||
|
||||
|
Just check for AC ( to GND) on both sides of C1. If there check the
supplies # 1, 2, & 3 for DC. Keep in mind most the time things in Sams flow left to right. Try to find a mid point & test voltage. Go upstream or downstream from there. 73 Zeno  LFOD !
|
| Audiokarma |
|
#6
11-01-2019, 02:56 PM
|
||||
|
||||
|
Quote:
__________________
To keep your tubes running smoothly, make sure to dust underneath the glass as well.
|
|
#7
11-01-2019, 06:10 PM
|
||||
|
||||
|
Quote:
__________________
To keep your tubes running smoothly, make sure to dust underneath the glass as well. Last edited by Dubis7; 11-01-2019 at 06:10 PM. Reason: Fixing "CD"
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
