|
R27 is the only one acting that way, and has been ever since the set was gotten working again.
Thus I have been suspecting the 56uf on place of the 50uf at C4 for some time now, I'm not even sure of the status of R106 which is under the PCB, this may be sending a wave slightly too big/small to that circuit on the convergence PCB making it ALMOST in range.
Obviously the 2 resistors from the cathode of the vert output to ground are OK R127/R126 ( also tied to pin 8 of HOT ) as there is no problems with sweep.
__________________
=^-^=
Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte.
いとおしい人のために
|
06-12-2022, 12:55 AM
Hybrid Mode
