CT-100 Dropping Power Resistor

[Electronic M]

I didn't even try to install resistors in the old ballast. I used metal case chassis mount power resistors bolted to chassis (the upright that holds the seleniums)to improve heat dissipation.... It's been in service 4 years now (sometimes it's on all day long) and is doing fine.

[Penthode]

Originally Posted by Electronic M

I didn't even try to install resistors in the old ballast. I used metal case chassis mount power resistors bolted to chassis (the upright that holds the seleniums)to improve heat dissipation.... It's been in service 4 years now (sometimes it's on all day long) and is doing fine.

What power rating resistors did you use? Does the chassis upright holding the seleniums get noticeably warm?

[Penthode]

I tried clamping the 330 ohm 50 watt resistor to the selenium rectifier frame hooked up the 120 vac to it and waited. Ever 10 minutes she was really cookin'!

It touched 130 degrees Celsius which is 266 Fahrenheit. Getting better: better that the resistor with no heat sink and reaching 175 Celsius.

I am going to think about this. The answer is perhaps a different heatsink and fan which plugs in the octal socket or a minor redesign of the power supply to eliminate or at least minimize the huge voltage drop requiring this big resistor.

[Electronic M]

Originally Posted by Penthode

What power rating resistors did you use? Does the chassis upright holding the seleniums get noticeably warm?

I don't remember, and I'm not sure if my mouser order history goes back that far. I think I rounded up (from my power calculations)to the nearest standard wattage and one of the parts was 50W.
I wanted to go double the wattage, but I think sticker shock on the parts I did buy and worse sticker shock on the 2X wattage stopped me (the 2X wattage may not have been available for one of the parts).

The chassis upright (especially where the resistors are) gets about as hot as a running tube (not something you want to touch). I didn't own a thermometer back then so no measurements were taken. I figure as long as the resistor is rated for higher wattage than it sees, then it should be fine. The chassis riser being hot shouldn't be a problem either...It's metal so it won't melt at those temps, and it would probably get that hot if it was next to a power tube anyway... there's really only wires, 2 diodes, 2 fuses and an octal socket on the riser so if you dress the wires to not touch the chassis there's really nothing that the heat can harm... Especially given the back is a very open metal mesh that lets the heat out well.
With how many tube heaters alone are in this set the ballast isn't that big of a heat producer in the grander scheme of things, and the original ballast put out the same amount of heat.