Motorola ts907 low hv

[Tim]

It intends to show .002 distributed across the resistor. When making a replacement put a .001 to ground on each end of the resistor so the total is .002

Is there another resistor that is covered by the black splotch?

[timmy]

Originally Posted by Tim

It intends to show .002 distributed across the resistor. When making a replacement put a .001 to ground on each end of the resistor so the total is .002

Is there another resistor that is covered by the black splotch?

No there is not only one for this area.

[dtvmcdonald]

Originally Posted by Tim

It intends to show .002 distributed across the resistor. When making a replacement put a .001 to ground on each end of the resistor so the total is .002

Is there another resistor that is covered by the black splotch?

A more common interpretation of the separate component intent of that figure
is two resistors of half the listed value in series with the listed cap value attached between their center to ground. That of course assumes that the big black dot is meaningless.

You really need to get or borrow a scope to sort out messy problems like these.

[Yamamaya42]

Originally Posted by dtvmcdonald

A more common interpretation of the separate component intent of that figure
is two resistors of half the listed value in series with the listed cap value attached between their center to ground. That of course assumes that the big black dot is meaningless.

You really need to get or borrow a scope to sort out messy problems like these.

and a better DVM.