Motorola ts907 low hv

[Yamamaya42]

Originally Posted by timmy

The schematic shows only the .0039 400v but no % for that cap so how am I to know what was in there. The horizontal.

It normally has it listed on the part, if it has no listing, a general rule of thumb is that it's a 20% part, unless otherwise indicated, and as always in these cases, it always helps stability to put in a higher tolerance part than you remove, because back when it was made it was a cost issue, putting in 10-5% or more parts was costly, but now, those parts are very cheap and effective.