|
|
|
#2
07-27-2023, 10:24 PM
|
|||
|
|||
|
Simpler question…shouldn’t I be able to take the RF output signal off the generator and see/confirm it on my scope? When I do this I get a waveform but it’s jumpy and my scope can’t give me a steady frequency readout. Am I doing something wrong? I’m not trying to sweep or anything else. I just want to check the output frequency and I can’t. I had the same issue with my Knight sweep generator. That makes me think I’m not doing something right
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode