|
Overscan Issue
This problem arose as a result of combining two sets into 1. They were both 40 inchers. The Westinghouse had a bad screen and the Element had a bad main board. These were both roadside finds and appeared almost identical inside. So I put the good main board into the one with the good screen. Everything just dropped right in. Or so I thought.
The result is a slight overscan at the bottom of the display where the crawl usually runs. Its really not a problem unless you like to read the crawls.
Question is: Is there any software to adjust this? Thanks.
__________________
|
03-24-2021, 07:58 AM
Threaded Mode