|
|
|
|
|
#1
12-09-2014, 07:34 PM
|
||||
|
||||
|
Drive circuits aging unevenly, or bad gun optics could be at fault, could also be CRT tester error.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 
|
|
#2
12-10-2014, 07:24 AM
|
||||
|
||||
|
When you grey scale these one of the bias controls should
be full CCW when done. In other words turn all 3 down & use 2 of them to balance the grey scale. The reason for the green tint & it being the control full CCW is the green gun is the strongest. Another CRT test you can do is a life test. Sometimes its built in but if not turn off the filaments & watch how fast the meters drop. Any that fall fast are not quite up to snuff. If they all fall slowly & apx the same rate you are good. 73 Zeno 
|
|
#3
12-11-2014, 05:05 PM
|
||||
|
||||
|
Quote:
Is it me or RCA red are a bit more orange than other brands?
|
 |
|
|
Hybrid Mode
