AK 30 Audio Xformers & Missing Resistor
 

I'm doing the cosmetics on the components of an Atwater Kent 30, but there's one data item which I'd like advice on before I proceed. Here's the data for the audio transformers:

https://lh4.googleusercontent.com/-u...30%2520610.jpg

The resistance of one of the coils varies a little more (I believe the technical term is "out of whack") from the specs than I've come to expect.

Should the primary of the 2nd audio should be a concern, or should I just proceed as it stands and see what happens?

There's also a resistor on the schematic which I haven't found yet. If I can't figure it out when I rewire the set, then I'll ask about that.

Many thanks.

My AK40 was further outa whack value wise, and still worked fine. I'd say don't worry too much.

Thanks.