Quote:
Originally Posted by static1701
I ordered all the replacement caps today. I had to get the Factory service manual because the numbers on the board did not match the numbers in the Sams parts list. I am debating removing the board from the chassis or just clip and solder. I don't really care about keeping it original... I just want it to work correctly.
|
If it is a 10L43 with holes under the PCB like mine you can split the difference... leave all the wires connected, remove all the hold down screws on the board, unscrew the vertical transformer, and lift the fingers that he the wires to the chassis...you can lift the board enough to get to all the pads underneath through the holes with a thin iron....you can leave all the wires connected this way.