CTC-4 Director 21

[Electronic M]

Originally Posted by SwizzyMan

Thanks for the kind words guys! The set is really shaping up now. But there is still a lot of work to be done both electrically and on the cabinet. Im having custom decals made for the decals located under the knobs. Im debating on whether to refinish it or not. Oh and Phil, I am using the factory RCA manual to go through the setup. I will take a look at the one on your page too. Convergence needs to be done before I can do purity since poor center convergence will make it hard to get good purity. Ill try and figure out convergence soon, but it sure is confusing!

As soon as you do purity it may throw dynamic and or static convergence off and to an extent vice versa....This will probably be an iterative process, touch up purity, touch up static convergence, rinse and repeat till it is right.

It may be wise to unplug the convergence yoke do the static and purtiy till right then plug it back in and go after the dynamic.....Make sure your H and V size and lin are right before doing the convergence since there will be interplay.