|
|
|
#12
07-08-2017, 04:34 PM
|
||||
|
||||
|
After leaving no stone unturned in the vertical circuit (which isnt many). I found only one barely out of tolerance resistor a 2.2meg 1/2w coming off G1 of the 6AQ5 vertical amp then goes to ground. Not sure it is too critical and its just barely off spec I mean like less than 1% off spec so I might just leave it. All caps are fine except I did replace a .039 which comes off the plate of the vertical amp and goes to the red cathode of the CRT. The original the maroon drop cap tested OK but I had a cap on hand and replaced it. Dont think it will make the vertical any higher though..
__________________
 Admiral C322C2 Regent (Restoring) RCA CTC-7 Pensbury (Restored) RCA CTC-5 Westcott (Restored) CRA CTC--4 Director 21 (Restoring) 
|
|
|
Threaded Mode