CTC-16 Tint issue

[reeferman]

How does the B/W picture look? If ok, then I would center on the 3.58 osc circuit next. Try this. Center your tint. Ground pin 2 of V703B 3.58 Osc tube. Adjust L702 reactance control coil for minimum # of vertical color lines/bars. Remove ground. Tune in a show of known good color quality. Set the tint control to midrange, adjust T703 3.58 Osc Trans for correct tint. Assuming you are successful, it gives you a place to start how far/fast the set is drifting. If you're lucky, you won't have to bother with it for a long time to come. Let us know how it turns out.