Motorola Color Television

[Stlouisian]

I have had to replace R145 a 100K resistor that was split into two that went to the focus control. I used my high voltage probe and only got 4KV off the focus rectifer. Also I had to replace C2 a 2Mf 350 Volt Electrolytic that is in the vertical section. Now I am only getting the picture showed my prior posts briefly because the picture fades to nothing after it is on a few minutes. The only voltage reading that I did take in the high voltage section that seems to be very low is on Pin 5 of the 6BK4. It should read 360 Volts and I am only getting 230 Volts. Anyone have any ideas where I should try and why I am losing high voltage? Thanks for any help.

Ross