|
|
|
#2
05-24-2009, 01:32 AM
|
||||
|
||||
|
Assuming that the sound and contrast problems were related to the horizontal , not a weak solder joint that was distubed when the chassis was moved .
I would suspect it to be more in the low voltage power supply . Check for a weak rectifier , is it tube or diode ? Are you running selemiums ? Also this could be caused by a weak power resistor . Is the contrast and sound are a seperate issue , I would start in the horizontal circuit , and also check to see that the yoke hasn't slid back a bit . Best of luck with it . 
|
|
|
Threaded Mode