|
|
|
|
|
#1
01-19-2011, 09:47 AM
|
||||
|
||||
|
Maybe the guys a dolphin trainer at sea world and he's been bringing his work home with him.
__________________
No wonder this circuit failed,it says "made in Japan"! 
|
|
#2
01-19-2011, 11:19 AM
|
||||
|
||||
|
Looks like the basement flooded and they ripped up the old floor covering.
I suppose those legs are original, but to me the set looks awkward propped on tiny pencil legs. (My black CTC-11 is the same, only more so. An immense color TV that takes two strong men to lift, with little legs that will snap if you say Boo. I unscrewed the legs and put it on a sturdy low table.) Kind of a cool TV otherwise, but in my book its value is more in the $50 to $75 range. Just my $0.02. Phil Nelson
|
|
#3
01-19-2011, 12:34 PM
|
|||
|
|||
|
My brother had that exact same set, but in a brown cabinet. The design is a bit unusual in that the pic tube and chassis are assembled as a unit on a plywood base. The cabinet which consists of only two sides and top, lifts off the base. Access panels in the base open for under-chassis servicing. The setup is quite functional but kinda flimsy and cheezy looking with the cabinet off.
My brother's was a tabletop set. I believe there was an optional matching stand available for making it a floor-standing 'console'. The set in the OP's post looks like it's sitting on a stool, as legs could not have been attached so near the center because of the big access holes. Legs would need to be attached out near the corners. Bill(oc) Last edited by old_coot88; 01-19-2011 at 12:48 PM.
|
 |
|
|
Hybrid Mode
