Mighty Monarch of The Air

[vts1134]

Originally Posted by old_coot88

Yep, but he's gotta disconnect one end, either the ground end as you suggested, or the top end. Doesn't matter which. While it's disconnected is a good time to also check continuity of the secondary winding of the transformer.
To the OP (original poster): is the capacitor across that winding (shown with dotted lines) actually in the set? If so, have you replaced it and/or verified that it's not shorted?
oc

Looking at the schematics I see that both coils are 2200 ohms. If I meter on my yellow arrows am I correct in thinking that it should be 4400 ohms?
The secondary of the transformer is good.
The third question about the capacitor across the winding in the schematics I cannot answer. I didn't see that before you mentioned it. It says that it's 75mmf, but it's not listed in the part list. Could that also be located inside the yoke housing?