RCA Non-Bonded Safety Glass removal?

[Kevin Kuehn]

Originally Posted by Phil Nelson

Let me know if you figure it out. The bottom piece on my CTC-7 glass bezel has some minor dents, so I was thinking of swapping the top & bottom pieces.

Finally got the bottom trim off.

The bottom trim comes off a little different than the top. After the safety glass was removed, I was then able to push inward on the top edge of the trim. I started on an outside corner, using inward rolling motion, while at the same time pressing down. You can also roll it in the middle, to help it release from the center two tabs. The top edge hooks over the retainer; the bottom is pressed under those four little tabs. It takes a little messaging to get the bottom lip to slide past those tabs.