Rca ctc-5

[DaveWM]

did the remaining two filter cans, very easy method again. going to lay off it for a while now, then will get on the paper caps. There are quite a few that are point to point (the chorma section is NOT on a pcb) On those I am prob just going to go pig tail method. The tube sockets are not the best quality and I don't want to goof them up trying to unsolder. The others on the bottom have some coils involved so again pig tail. I know some purest think this is sloppy work, but I think its less invasive, and since I have no way of determining the operating status, I dont want to create a problem.