Anyone have any Zenith Convergence Coils?

[Findm-Keepm]

Originally Posted by zeno

Another tool that are almost a must have is a LONG 1/4" (#8)
nutdriver. Xcelite used to make it. About 30" long with a
magnet, gets to screws holding tuners & deep in anywhere.
Be sure a used one isnt worn. Should be lots of NOS around.
They also made a yellow handled one (dont remember size)
and a phillips. The phillips is essential for some old JP sets.

73 Zeno

I used to sell Xcelite - the nutdrivers were prefixed as follows:

P - Pocket (P8=Pocket Red=Pocket1/4")
Number only = 5" (nominal) shaft (8=standard length Red=1/4")
HS - Hollow Shaft, beefier, but bulkiness limited their use.
L = Long = 10" (nominal) shaft
LL = the longest, as you mentioned, the LL8, also available back then in the yellow, and through special order, the green.

Now it's all 99-series if you need longer lengths or magnetic tips in most sizes. The pocket, and standard (5") are being produced, and the L8 and L10 nutdrivers are also being produced.

Xcelite's XST-series (Xtra True Tip) Phillips screwdrivers are the best. I have a set I bought in 1983, still going, in all sizes and lengths. Best tool investment I ever made. Sadly, not made anymore.

Cheers,