Time to get this site upgraded, so we are passing the hat around. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html
Go to Page...
We appreciate your help
in keeping this site going.
I used a .033 film capacitor for the .035 paper axial cap, and two .0033 Orange Drops paralleled together for the .0068 axial paper cap.
These caps were right off the vertical tube socket,
I was wondering if that might be a problem, substituting those type?
That sub should be fine. Check for bad resistors, and check the transformers in the vertical circuit (usually a small one for the oscillator, and a bigger one to drive the yoke).
05-16-2014, 06:33 PM
Threaded Mode