|
|
|
#18
08-02-2014, 10:21 PM
|
|||
|
|||
|
I nearly popped for the 6" DA air sander at HF today, but they did not have any fine (wanted 600 grit) sanding disk so just did it by hand.
I sanded the pass side top fender down to the pin stripe, and the edge of the top down a door piller, down to the same pin strip also on the pass side. Using the pin stripe as a nice panel break. Got it masked off, if weather looks good tomorrow will shoot some rattle can at it and see how it looks. 
|
|
|
Threaded Mode