chromacolor or CC II?

[zeno]

Good to see it on the bench.
Minor width problem most likely H. output tube.
damper & H. osc tubes also possable and filter can
( in front of tripler ).
The CRT looks very strong. Blue lateral is the white
part on the neck. Has 2 rings with tabs for purity &
the twist magnet is the blue lat. Give that a turn to put
the blue on the yellow. Clean tuner & hopefully the
snow comes back.
Chromatic switch. Note the color, tint, bright & contrast
knobs have holes. There is a second set of controls for the
chromatic. With it on ( orange ) the regular controls dont
work you use the screwdriver to adj it. When off the outside
controls work.
Color problem.
1) clean normal/align switch on top of chassis between the
color module. If that dont work......
2)remove the 2 color modules ( 9-27 & 9-?? ) if the IC's
are still plug in remove them & clean sockets. Be sure to note
the markings to put them back in right. Spray the module
contacts also. If that dont work......
3) put on a color picture. Put norm/align switch in align.
Adjust the APC control on the 9-27 board for the FEWEST bars
rolling through picture. Return to normal.
That will keep you busy for a while !!

73 Zeno