|
|
|
#33
03-02-2015, 10:40 AM
|
||||
|
||||
|
ok, I put on tube shields, put the b plus wire back on, replaced a cap that I was told to test and here is what I have. The vertical is locking, the horizontal is jittery, and the image on the screen is a negative image...
At least it appears that way to me and still is washed out like the signal too strong or too weak. 
|
|
#34
03-02-2015, 01:12 PM
|
||||
|
||||
|
It was mentioned to check the cap in b plus line to pin 5 of the video amp, which I replaced again to be safe. There is a ceramic cap in parallel with a coil in that line that might also be an issue so i did grab a replacement for it and will try it tonight...hopefully!
|
|
#35
04-18-2015, 04:10 PM
|
||||
|
||||
|
i put in a new cap.....it is in parallel with a 4.5 min coil coming off of the video amp.
the picture is better,but retested the crt and it is shorted............and i do not have a replacement. so this project is on hold for now.
|
| Audiokarma |
|
#36
04-18-2015, 04:48 PM
|
||||
|
||||
|
Is it a heater-cathode short? If so just get an isolation transformer for the heater (some 'brighteners' were not brighteners, but rather isolation transformers) or add a separate heater transformer for the CRT.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4
|
 |
|
|
Linear Mode
