|
Jeepers, I sure don't remember anything near that involved. I did use a bias box initially, but found out you get the same results with or without it.
The hookup is purely intuitive and super simple (see attachment). Just tape a turn of wire around the mixer/osc tube as the injection point. Disable the LO by putting the channel selector on a hump between detents. And you're good to go, bias box optional (others' opinions may vary). The procedure is actually fun to do, and you can do it in a morning. Just keep the signal attenuated to the lowest level consistent with good response.
|
02-11-2016, 10:28 PM
Threaded Mode