Pilot tv crt

[timmy]

Originally Posted by Eric H

I noticed you said in post #7 that Ceramic Disc caps were used, if those are the high voltage caps in the vertical circuit then that's probably your problem.

Discs will work in the horizontal but not the vertical, they will cause linearity problems.

Yes it did have ceramics in the deflection but I took them out and put asc caps but that was not the problem so here is an update. I believe these 2 caps were integrator caps, 2 -.05 caps and I have a tester and they tested good so I left them then decided to take one out at a time and sub well the SAMs shows .05 caps belong there in the schematic but listed in the parts shows unless I looked at it wrong .005 so I don't know. Anyway I put .033 for one .05 and the other .47 and it fixed it perfect although I tried it the other way and didnt work then switched them back and it's done finally. The .47 went between v13 and v14 and the .33 from v13 to the 120 k below it. Here are befor and after pics.