|
70 sets, and you're getting 2 more Zenith B&W consoles from me later next month! You do get faster at it the more you sets you fix.
When testing resistors, it often happens that the ends of the resistor are connected through some other path in the circuit, and you get a lower reading than you should. You can sometimes look at the schematic and work out what that should be, but often it's just easier to remove one end of the resistor from the circuit and then test it that way.
But if the set works normally before it warms up and the problem is caused by a bad resistor, it won't test that bad when it's cold.
Last edited by Adam; 07-29-2016 at 10:59 AM.
|
07-29-2016, 10:41 AM
Threaded Mode