|
|
|
#20
10-06-2016, 02:48 PM
|
||||
|
||||
|
Found yet another problem: someone at some point replaced components (I can't tell if this was recently or back during the set's service life) in the HV cage and did a piss poor job soldering. If I even look at the HV adjustment pot wrong I get bad arcing across a terminal strip in the bottom of the cage. The fly, thank God, wasn't damaged in all of this. I guess I'll sort out the mess in the HV cage first and move on from there.
|
| Audiokarma |
|
|
Threaded Mode