Quote:
Originally Posted by Electronic M
I'd keep the power tranny, convergence adjustment board (the first set you find with a bum convergence pot will make you gad you kept a board full of spares), as much of the chassis as feasible, and the mask (you could make your own test jig with it).
|
Forgot to say before, I didn't know convergence pots could just up and quit because they seem pretty sturdy and aren't moved much. I have a few from a set I couldn't save, but I kept them mostly for their knobs. I don't see a way to separate the knobs, but I had one break off in another set. It was discolored, probably decayed by heat. If any more had broken I probably would have replaced the pots. A small screwdriver was sufficient in this case.
11-17-2016, 07:48 PM
Threaded Mode