Ts18 verticle problem

[timmy]

In a previous post there is a pic of the set working with a really good picture but this will only happen when I parallel a .01 cap or even a 1 meg resistor with the .004 cap at the 6sl7 without that the other pic shown in the previous post is what I got so if these caps are not working then how would I get such a good pic otherwise. I know I need the right caps and I intend to get them but now I feel something else is going on here because when I put the new caps in and if I have the same problem then I'm back to square one looking for it. When I have the cap or resistor paralleled the vert hold works fine but I'm Alittle short on linearity so it seems as if there is another small problem that I'm not finding. I tried another .004 cap and made no difference. Resistance checks at the 6sl7 are right on but on v13 pin 2 SAMs shows it should be 20k to 520 ohms seems like a big swing but I'm getting only 2.2 k .