|
|
|
#11
06-23-2017, 10:47 AM
|
|||
|
|||
|
BTW, I'm getting ready to do the main board. I have the film caps, resistors, and the 2 micas will be replaced. Is there anything else that I need to be on the lookout for? These boards look very similar to the Predicta boards. I'm concerned about the networks. Should I just shot gun them and be done with them? Which ones are usually bad if any? As with most, I only want to pull this board once.
BTW, I'm leaving all the ceramic discs alone. Right? 
|
|
|
Threaded Mode