Westinghouse K840CK15 Restoration

[etype2]

UPDATE, NOVEMBER 14, 2018, Day 106

From Mike,

“After a brief hiatus, recapping continues. Under the RGB Adders and amp circuits was a big resistance array mounted to terminal strips. This bank of parts prohibits access to the bottom of the chassis where the RGB adders and amp circuits are. After some study I determined that I can disconnect 4 wires that were going from the resistance array down to the RGB circuits and then remove the screws on the mounting plate allowing the entire array to “fold away” and “down” from the part of the chassis that I needed access to.

Picture #1 The new VDC transformer mounted but not yet wired.

Picture #2 Shows my “impossible access” to the capacitors that need replacing.

Picture #3 Shows the assembly pulled away and folded down after disconnecting the 4 wires. Full access to the components is now possible.

Picture #4 All new caps and some new resistors installed.

Picture #5 The assembly re-installed and the wires re-connected.”









Link to restoration page: https://visions4netjournal.com/westinghouse/