It's been a couple of days. I had a few things around the house to get done and I also had to make another round of PC boards for my Network sales.
I finished the Vertical section this evening. The Vertical section contained a couplate or network! While I was going to make some more Network PC boards I drew up one for the Vertical Integrator network. It consisted of 3 resistors and 3 caps. Simple. I first checked the original and it has 3 resistors between leads 2 and 3 that should add up to 38.4K. These measured out to 48.1K. A 25% difference. This one has to go!
Some before and after pictures. If you look closely you can see the brown Network under the right hand side terminal strip.
01-19-2019, 07:51 PM
Threaded Mode