|
|
|
#11
10-22-2019, 11:16 AM
|
||||
|
||||
|
Worked with convergence PCB a bit last night, new diodes had very little / no effect, still can't get R/G at the top as good as left/ right/ bottom, ( perhaps never will, IDK ).
Moving the conv, yolk forward/ back a bit did not help much. Have NOT tried the new caps in it yet, will try tonight to see if it changes anything. The biggest problem I see is the R/G horz top lines are not linear, red above green in one side, and then green above red in the other, this is not seen anyplace else, the R/G can ALMOST be lined up, but is slightly still off.
__________________
=^-^= Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte. いとおしい人のために 
|
|
|
Threaded Mode