|
|
|
#47
11-29-2022, 10:23 AM
|
||||
|
||||
|
Perfect! I want to see the diffuser plastic mounting to see if I can recreate it to get rid of my warped version.
__________________
“Once you eliminate the impossible...whatever remains, no matter how improbable, must be the truth." Sherlock Holmes. 
|
|
#48
11-29-2022, 05:52 PM
|
||||
|
||||
|
Dave, I scanned the document and created a PDF. If you PM me your email address I can send you a copy of the PDF. I scanned as individual JPEGs then assembled them into a PDF with OpenOffice Draw (free software). The pictures on the pages seem a little small but I was hesitant to enlarge since they may not fit on a printer. I saved the Draw format so the pages can be resized if necessary.
|
|
#49
11-29-2022, 06:03 PM
|
||||
|
||||
|
Great...PM to follow with email. It should tell me what I need. And I went to a craft store today and bought a sheet of opaque plastic to that should work for my receiver problem. And if anyone needs a square, let me know. Free.
__________________
“Once you eliminate the impossible...whatever remains, no matter how improbable, must be the truth." Sherlock Holmes.
|
|
#50
11-30-2022, 01:29 PM
|
||||
|
||||
|
I submitted a copy of the Receiver .pdf to the ETF website. It is 16 mb compressed from 40 mb. (about 36 pages). I asked Steve if that was too large for the ETF site. I compressed it to 2 MB but it was hard to read. There appears quite a bit of black marks on the edges of the pages. It might compressed better if they were cleaned up.
|
| Audiokarma |
 |
|
|
Linear Mode
