Quote:
Originally Posted by damen
I regularly used to jumper those things out because of customer complaints. If you can see the two red wires connected to it from the back, just cut them off and twist the bare ends together. If they're not visible, the plastic front mask of the set can be tilted out forward enough to access it. Requires one of those long quarter inch nut drivers.
|
I found the courage to go in tonight. Success. All it took was some snipping, stripping, and electrical tape. Thanks!
Images for anyone interested:
Two wires on the upper left side.
The resistor being wired to this connector minimized the amount of time my hands spent in there.
Here's a
before and
after comparison.
01-31-2024, 12:21 AM
Threaded Mode