|
|
|
#7
06-12-2024, 01:59 PM
|
||||
|
||||
|
The only thing I can think of, is out of tol resistors in the sync area, especially near the 6AL5 phase det, when I restored my FADA 630TS clone, many resistors were replaced, if perhaps the 2 470k resistors and the 1m are a bit off, it might upset the horz phasing, I'm sure they were replaced with 1% new in my set, as well as most of the other resistors in the sync area that did not test within 10% what they should have.
__________________
=^-^= Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte. いとおしい人のために 
|
|
|
Threaded Mode