|
|
|
#33
03-19-2026, 05:16 PM
|
||||
|
||||
|
Well I did the G2s over again. I increased the green until I saw a slight increase in intensity and then added in the other guns to get the best grayscale I could with my eyes. However, when I tried to set the contrast and brightness, I had to go full on the brightness in order to get a decent picture. I figured that if this was full brightness, I needed to go higher on the G2s, so I started over and this time brought the green up a little more than last time. Again, it needed just about full on the brightness control. Third time is a charm? I did it again and put the green up even more, somewhere just shy of 50% on the control. After adding in the other guns for the grayscale, I was able to get the brightness level with a little to spare. According to the CRT tester, all guns are good and very close to each other, so I don't think it's the CRT. Maybe something in the aging electronics.
Anyway, now I just need to replace the broken pot on the convergence board to finish it up. I am kicking myself for even touching it as I was pretty darn close to perfect with the only misalignments on the far corner and a bit on the right edge. Oh well, that'll teach me.
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650 
|
|
|
Threaded Mode